Abstract

BackgroundPercutaneous lag screw fixation is an alternative treatment for non-displaced or minimally displaced posterior column fractures. This study aims to explore new fluoroscopic views of the acetabulum for safe percutaneous insertion of posterior column lag screws.MethodsAxial computed tomography (CT) scans were taken of sixteen embalmed adult cadavers. The axial CT images at the level of the middle height of the acetabulum were selected. The angle (angle α) between the posterior cortex of the posterior column (PCPC) and the line intersecting the axial plane and the coronal plane, and the angle (angle β) between the medial wall and the line intersecting the axial plane and the sagittal plane were identified and measured. Tangential views of the PCPC and medial wall were obtained by referencing the measured angles. A lag screw was inserted into the posterior columns of the sixteen pelvic specimens under fluoroscopic guidance using an iliac oblique view and the two tangential views. CT scans were performed to evaluate the lag screw position. Axial CT images of 52 volunteers were obtained and the angles α and β were measured following the same methods used for the cadaveric specimens.ResultsThe angles α and β for the specimens were 29.3±2.8.1 and 8.1±1.4 degrees, respectively. On the tangential view of the PCPC, the posterior cortex appears as a nearly straight line between the lesser and greater sciatic notches. On the tangential view of the medial wall, the medial wall appears as a distinct straight line. Using these radiographic images, the lag screws were inserted into the posterior columns of bony pelvic specimens. Screw placement was confirmed by CT, and found to be fully intraosseous in all cases without any cortical breaches. The angles α and β were 30.4±4.1 and 9.2±1.9 degrees for male volunteers and 28.5±3.7 and 7.7±1.8 degrees for female volunteers, significant difference in these angles between cadaveric specimens and human volunteers.ConclusionThe tangential views of both the PCPC and medial wall can be obtained following the aforementioned methods The oblique iliac view and the two tangential views enable safe insertion of posterior column lag screws.Electronic supplementary materialThe online version of this article (doi:10.1186/1471-2474-15-303) contains supplementary material, which is available to authorized users.

Highlights

  • Percutaneous lag screw fixation is an alternative treatment for non-displaced or minimally displaced posterior column fractures

  • The tangential views of the medial wall of the acetabulum can be obtained by rotating the C-arm unit outward approximately 9.2 or 7.7 degrees from the position where the anteroposterior view of pelvis is taken

  • We introduced the tangential views of the posterior cortex of the posterior column (PCPC) and the medial wall of the acetabulum

Read more

Summary

Introduction

Percutaneous lag screw fixation is an alternative treatment for non-displaced or minimally displaced posterior column fractures. The dense scar tissue, contractures and problematic hardware commonly encountered after failed open operation of acetabular fractures can be avoided with the percutaneous technique [10]. This procedure is technically demanding and limited by narrow bony corridors [11]. It is essential to improve the accuracy of lag screw insertion into the posterior column to reduce the risk of iatrogenic injury to the hip joint, adjacent neurovascular structures and intrapelvic organs [13,15]

Objectives
Methods
Results
Discussion
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call