Flume testing of seepage velocity monitoring using optic fiber distributed temperature sensing for embankments

Abstract

Purpose Distributed temperature sensing (DTS) can identify locations and factors of seepage in embankments. Inspired by the classical transient hot-wire method (THW), the focus of this paper is to investigate the feasibility and propose a calibrated method of seepage velocity monitoring using the optical fiber DTS. Design/methodology/approach According to the definition and the measurement of thermal conductivity, the nominal thermal conductivity, which comprehensively reflects the influence of heat transfer and seepage factors, is proposed and the corresponding solution is also derived. Then, a flume testing platform of an embankment seepage monitoring system composed of the optical fiber heat-up subsystem, the seepage controlling subsystem and the optical fiber DTS subsystem is designed and built. Meanwhile, the data processing and assistant analysis subsystem (DPAAS) is also developed to effectively acquire the experimental data of concerned locations and obtain the corresponding nominal thermal conductivity under various seepage conditions. Based on these setups, a series of laboratory flume experiments are carried out under controlled velocities and heating powers. Findings The plots of recorded temperature rise versus natural logarithm of time allow the calculation of nominal thermal conductivities, and then the seepage velocity monitoring model particular to the experimental setup is successfully established with satisfactory precision. Research limitations/implications Considering the complexity of water flow in embankments, a seepage flume that matches the natural system, allowing for larger experimental model scales, various water temperatures, various engineering materials and a wider range of seepage velocities, should be investigated in future. Practical implications The combined THW and DTS method provides promising potential in real-time seepage monitoring of embankment dams with the help of the developed DPAAS. Originality/value In this work, we performed a flume testing of seepage velocity monitoring platform using optical fiber distributed-temperature sensing for embankments based on the transient hot-wire method. Through the testing of data, the seepage velocity monitoring model particular to the experimental setup was established. The results presented here are very encouraging and demonstrate that the DTS system can be used to monitor the temperature and the seepage factors in field applications.