Abstract
Injection molding is one of the most extended plastic processing technologies. Delivery of polymer melts into the mold cavity is the most important stage of the injection molding process. This paper shows the influence of mold cavity surface roughness and technological parameters on the flow length of thermoplastic elastomers and rubber into mold cavity. The fluidity of polymers is affected by many parameters (mold design, melt temperature, injection rate and pressures) and by the flow properties of polymers. Evaluation of the data obtained by experiments where the testing conditions were widely changed shows that quality of the cavity surface does not affect the length of flow.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
