Fluid circulation and formation of minerals and bitumens in the sedimentary rocks of the Outer Carpathians – Based on studies on the quartz–calcite–organic matter association

Abstract

Different methods have been used to examine minerals and/or solid bitumens in three adjacent Carpathian regions of Poland, Ukraine and Slovakia. The minerals fill smaller and larger veins and cavities, where they occur either together or separately. They usually co-occur with the solid bitumens. All δ13CPDB values measured for calcite lie in a relatively wide interval between −6.25‰ and +1.54‰, while most values fall into the narrower interval from below 0 to about −3‰. The general range of calcite δ18O results for the whole studied region is between +17.13‰ and +25.23‰ VSMOW or from about −11 to −5‰ VPDB, while the majority of these values are between +20.0 and 23.5‰ VSMOW (−10.53 and −8.00‰ PDB, respectively). δ18OVSMOW results for quartz vary between +23.2 and 27.6. The carbonate percentage determined in some samples falls between from <2% CaCO3 to >90% CaCO3, while the TOC values changes from 0.09% to over 70%.The aliphatic fraction predominates in all studied samples, mainly in bitumens and oils. The composition of the aliphatic fraction is relatively homogeneous and points to a strong aliphatic, oil-like paraffin character of the bitumens. Such a composition is characteristic of the Carpathian oils and different from the rocks studied that contain the higher percentage of a polar fraction. The content of the aliphatic fraction in bitumens is only slightly higher than that in two oils used for comparison. The distribution of n-alkanes is variable in rocks, solid bitumens as well as inclusions in quartz and calcite. Two groups of bitumens may be distinguished. Those with a predominance of long-chain n-alkanes in the C25–C27 interval (in some cases from C23–C25 and without or with a very low concentration of short-chain n-alkanes in the interval of C14–C21) show also a high content of isoprenoids i.e. of pristane (Pr) and phytane (Ph). In all but one bitumen samples, Pr predominates over Ph. The second group comprises oils and rock samples with a characteristic predominance of short-chain n-alkanes in the interval from C13–C19 and a low percentage of the long-chain n-alkanes from the n-C27–n-C33 interval. Pristane and phytane exhibit a concentration comparable to that of C17 and C18n-alkanes with a Pr predominance over Ph. Due to high maturity, only small amounts of the most stable compounds from the hopane group have been observed in the samples, also oleanane in one case. Among the aromatic hydrocarbons, phenanthrene and its methyl- and dimethyl-derivatives are dominant in bitumens, source rocks and inclusions in calcite and quartz. Occurrence of cyclohexylbenzene and its alkyl-derivatives as well as cyclohexylfluorenes in solid bitumens suggest that they formed from oil accumulations under the influence of relatively high temperatures in oxidizing conditions.Homogenization temperatures for aqueous/brine inclusions in quartz within the Dukla and Silesian units (Polish and Ukrainian segments) are between 125 and 183.9 °C, while salinities are low in the interval of 0.2–5.5 wt% NaCl eq. The inclusions in calcite homogenize at higher temperatures of almost 200 °C and the brine displays higher salinity than the fluid in the quartz. Two quartz generations may be distinguished by inclusion and isotope characteristics and the macroscopic diversity. Oil inclusions homogenize at 95 °C. One phase inclusions in quartz contain methane, CO2 and nitrogen in variable proportions.