Abstract
The surface structure of powder particles, which allows free flow of copper powder, was examined. It has been shown that a sufficiently dense surface structure which permits free flow will be obtained if apparent density is higher than 2.2 – 2.3 g/cm3. Such a surface structure can be obtained by reversing current electrodeposition of powder at considerably lower apparent densities of powder due to selective dissolution of subparticles during anodic time of reversing current wave. The surface structure of copper powder particles is discussed and correlated with the lowest apparent density at which the copper powder can still flow.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
