Flow Visualization for CO2/Crude-Oil Displacements

Abstract

Abstract Results of visual observations of high-pressure CO2 floods are reported. The displacements were performed in two-dimensional (2D) pore networks etched in glass plates. Results of secondary and tertiary first-contact miscible displacements and secondary and tertiary multiple-contact miscible displacements are compared. Three displacements with no water present were performed in each of three pore networks: (1) displacement of a refined oil by the same oil dyed a different color; (2) displacement of a refined oil by CO2 (first-contact miscible); and (3) displacement of a crude oil at a pressure above the minimum miscibility pressure. In addition, three tertiary displacements were performed in the same pore networks: (4) displacement of the refined oil by water, followed by displacement by the same refined oil dyed to distinguish it from the original oil; (5) tertiary displacement of the refined oil by CO2; and (6) tertiary displacement of crude oil by CO2. In addition, recovery of oil from dead-end pores, with and without water barriers shielding the oil, was investigated. Visual observations of pore-level displacement events indicate that CO2 displaced oil much more efficiently in both first-contact and multiple-contact miscible displacements when water was absent. In tertiary displacements of a refined oil, CO2 effectively displaced the oil it contacted, but high water saturations restricted access of CO2 to the oil. The low viscosity of CO2 aggravated effects of high water saturations because the CO2 did not displace water efficiently. CO2 did, however, contact trapped oil by diffusing through water to reach, to swell, and to reconnect isolated droplets. Finally, CO2 displaced crude oil more efficiently than it did the refined oil in tertiary displacements. Differences in wetting behavior between the refined and crude oils appear to account for the different flow behavior.