Year-end Sale % OFF 
Abstract
The behavior of the flow stress of Al-Fe-V-Si heat-resistant aluminum alloy prepared by spray forming during hot compression deformation was studied. The results show that the true stress-true strain curves of the spray forming Al-Fe-V-Si heat-resistant alloy are characterized by a high true stress occurrence at the early stage of compression, followed by a steady flowing due to recovery and strain softening because of dynamic recrystallization. The flow stress of the alloy decreases with increasing deforming temperature and increases with increasing strain rate. The flow stress of the spray forming Al-Fe-V-Si heat-resistant aluminum alloy during hot compression deforming can be described by constitutive equation in hyperbolic sine function．The deformation activation energy of the alloy during hot deformation by Sellars-Tegart equation is much higher than those of the conventional aluminum alloy. The deformation activation energy decreases with decreasing strain rate at the beginning, then increases with decreasing strain rate. Keywords：Al-Fe-V-Si alloy；heat-resistant aluminum alloy；hot compression deformation；flow stress
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
