Abstract
Flow regime analysis on the results of pressure build-up Z-01 well test was conducted to determine the type of flow that occurs in each time region section. In the early time stage there is a flow which is dominated by linear flow which is then followed by bilinear flow. At the middle time there is a radial flow where the pressure disturbance has spread towards the reservoir. In the late time flow stage is dominated by steadystate flow where the flow is affected because there is a support pressure caused by the constant pressure boundary. In the analysis of pressure build-up used to determine reservoir parameters can be used in the middle time region. This is used because the plot results between ΔP vs. log HTR (Horner Time Ratio) are straight lines which can be used to calculate reservoir parameter values such as permeability (k), formation damage factor (s). This test was analyzed using the Ecrin software and obtained a dual porosity model with a permeability value of 4.8 md, skin -3.57. From the analyzed model, it is obtained that the well fracture-finite conductivity model means that the Z-01 well has been stimulated to increase production.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Earth Energy Science, Engineering, and Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.