Abstract
The flow field formed when an aluminum ribbon is produced by twin-belt rapid solidification is simulated with the solution algorithm (SOLA)-volume of fluid (VOF) method, and the influence of casting speed and cooling-belt velocity on the flow field is analyzed for a given ejection nozzle size. It has been found that the flow field can be filled well when the width of the ejection nozzle outlet is the same as that of the up slit of the cooling belt. When the ejection nozzle outlet is wider than the up slit of the cooling belt, the aluminum fluid can fill well if only the casting speed matches the cooling-belt velocity properly, otherwise under filling occurs in some areas in the cooling zone.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of University of Science and Technology Beijing
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
