Abstract
This work employees the modification of the Reynolds equation for computational efficiency by analyzing rough surfaces in the hydrodynamic flow regime through the use of flow factors. This analysis is aimed towards modeling the surface interactions and pressure variations across power cylinder components of an internal combustion engine, namely the piston ring and cylinder wall. The Patir and Cheng equations are for general surfaces that accounts for the overall effect of roughness and anisotropic structure. However, rough surfaces are not fully characterized by these two parameters and therefore the aim of this paper was to provide flow-factors specific to the cross-hatched cylinder liner surfaces and piston ring interface. These interacting surfaces were measured directly through the use of a profilometer. Average flow factors are derived via full deterministic solution of the Reynolds equation over rough surfaces to model the pressure and shear variations relative to smooth surfaces. These flow factors can then be used to consider the effect of roughness in lubrication problems without deterministically modeling roughness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
