Flow behavior and processing map for hot deformation of ATI425 titanium alloy

Abstract

Flow behavior and processing map play important roles in the hot deformation process of titanium alloys. In this research, compression Gleeble tests have been carried out to investigate the stress–strain relationship at temperatures ranging from 700 to 1000°C and strain rates ranging from 0.001 to 1s−1 for ATI 425 titanium alloy. Arrhenius type constitutive equation was obtained to describe the compressive flow behavior with modification of additional deformation dead zone, friction model, temperature model and strain rate. The introduction of novel calculation method for α value in Arrhenius equation gives more accurate fitting than traditional one. Processing maps were drawn based on the distribution of dissipator co-content, and optimized deformation temperature and strain rate range obtained. It is proven to be accurate and effective through the experimental results. The microstructure analysis shows that more dynamic recrystallization can be achieved in the area with larger η value on the processing map.