Flow and heat transfer studies of multijet impingement cooling for different configurations: A review

Abstract

AbstractIncreasing the gas turbine engine's turbine intake temperature has long been a potential strategy for increasing the specific work output of the engine. However, the melting temperature of the turbine blades and vane material limits the maximum intake temperature. As a result, internal and external cooling techniques are commonly used to maintain the vane material in a safe condition. This study provided an overview of internal impingement cooling to highlight the significance of geometrical variations, such as flat plate, curve plate, and actual vanes. It was observed that flat and curved plate impingement heat transfer studies were reported extensively, whereas limited studies were found on the conjugate effects on airfoil surfaces. The importance of conjugate heat transfer studies and their impact has recently been described in the literature. In most of the literature, a wide range of instruments, such as Laser Doppler Velocimeter, Particle Image Velocimeter, liquid crystal sheets, and so forth, were used for experimental investigations. According to most studies, the local value of internal surface temperature and heat transfer coefficient are vital factors of local flow behavior. Jet‐to‐jet spacing, jet‐to‐plate spacing, jet hole diameter, and jet Reynolds numbers played a crucial role in both numerical and experimental analyses. Different geometric variations strongly influence flow behavior. Therefore, the usual method for determining interior temperature distributions and heat transfer coefficients by considering generalized geometries like the flat and curved plate may not produce accurate conjugate solutions. Most of the computational studies on the flat and curved plate indicate the usage of κ−ω shear stress transport and κ–ε realizable model to predict the heat transfer coefficient.