Flocculation of montmorillonite by some hydrophobically modified polycations containing quaternary ammonium salt groups in the backbone

Abstract

AbstractThe flocculating efficiency of some hydrophilic/hydrophobic cationic polyelectrolytes on montmorillonite suspension in water was investigated as a function of both the polycation structure and the flocculation parameters: polycation/montmorillonite contact time, suspension pH, polycation dose, and temperature. Cationic polyelectrolytes with quaternary ammonium salt groups in the backbone and hydrophobic side chains (hexyloxypropyl, PCA5H1 and PCA5H2; and decyloxypropyl, PCA5D1, respectively) were used as flocculants. The flocculation was time dependent. A negative influence of the stirring time and of the abrupt variation of pH from basic to acidic on the separation efficiency was evidenced. The increase of the polycation dose from 0.58 mg polycation/g montmorillonite up to 1.74 mg/g montmorillonite showed a positive influence on the sedimentation of montmorillonite particles for all the polycations taken into account. The influence of the polycation structure was reflected in the lower turbidity found in the case of the polycation PCA5D1 compared with that of PCA5H1, at the same concentration; this reflects the positive influence of the hydrophobicity increase on the suspension separation. A common characteristic for all the polycations is that, for more than about 60 min of settling, the lowest turbidity was found at 25°C and the highest at 5°C. The turbidity found at 15°C was in between, both before and after 60 min of settling time. © 2002 John Wiley & Sons, Inc. J Appl Polym Sci 84: 871–876, 2002; DOI 10.1002/app.10371