Abstract

Floating solar photovoltaics, or floatovoltaics (FPV), are a relatively new form of renewable energy, currently experiencing rapid growth in deployment. FPV decarbonises the energy supply while reducing land-use pressures, offers higher electricity generating efficiencies compared to ground-based systems and reduces water body evaporation. However, the effects on lake temperature and stratification of FPV both sheltering the water’s surface from the wind and limiting the solar radiation reaching the water column are unresolved, despite temperature and stratification being key drivers of the ecosystem response to FPV deployment. These unresolved impacts present a barrier to further deployment, with water body managers concerned of any deleterious effects. To overcome this knowledge gap, here the effects of FPV-induced changes in wind speed and solar radiation on lake thermal structure were modelled utilising the one-dimensional process-based MyLake model. To resolve the effect of FPV arrays of different sizes and designs, observed wind speed and solar radiation were scaled using a factorial approach from 0% to 100% in 1% intervals. The simulations returned a highly non-linear response, dependent on system design and coverage. The responses could be either positive or negative, and were often highly variable, although, most commonly, water temperatures reduce, stratification shortens and mixed depths shallow. Modifications to the thermal dynamics of the water body may subsequently drastically alter biogeochemical processes, with fundamental implications for ecosystem service provision and water treatment costs. The extreme nature of response for particular wind speed and solar radiation combinations results in impacts that could be comparable to, or more significant than, climate change. As such, depending on how they are used, FPV have the potential to mitigate some of the impacts of climate change on water bodies and could be a useful tool for water body managers in dealing with changes to water quality, or, conversely, they could induce deleterious impacts on standing water ecosystems. These simulations provide a starting point to inform the design of future systems that maximise ecosystem service and environmental co-benefits from this growing water body change of use.

Highlights

  • Increased energy demands and the urgent need to decarbonise are prompting the rapid deployment of renewable energy technologies

  • Increases in surface water temperatures occurred only in scenarios when wind speed was reduced considerably more than solar radiation

  • By simulating the response of a lake to floating solar photovoltaics (FPV) deployed at varying extent, this study has demonstrated patterns of increased impact with increased perturbation, ranging from negligible to very large

Read more

Summary

Introduction

Increased energy demands and the urgent need to decarbonise are prompting the rapid deployment of renewable energy technologies. One such technology, solar photovoltaics (PV), has experienced exponential growth over the past 25 years (IEA, 2019) and accounted for 57 % of newly installed renewable energy capacity in 2019 (REN21, 2020). Conservative estimates suggest that FPV has a global potential of 400 GW-peak (World Bank Group et al, 2018), demonstrating the likely widespread uptake of this renewable energy technology. Global cumulative FPV capacity more than trebled among the top 70 FPV systems from 2018 to 2019 (Solar Asset Management, 2018; Solarplaza, 2019; World Bank Group et al, 2019), with a forecasted annual average growth rate of 22 % (Cox, 2019).

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call