Flexural strengthening of RC beams by advanced concrete canvas

Abstract

AbstractIn this study, concrete canvas (CC) layers were used as a novel method to strengthen reinforced concrete (RC) beams because of their flexibility, rapid installation, fast curing, and rapid strengthening. Due to the importance of the CC mechanical properties, various combinations of cement including ordinary (OPC) and High Alumina (HAC), as well as silica fume, were investigated to determine the optimal mixture for strengthening RC beams. The results indicate that substituting 75% of HAC with OPC significantly boosted flexural strength by 33%, and increased tensile strength in the warp and weft directions by 25% and 21%, respectively. The study examined six RC beam specimens in a four‐point flexural test, assessing their flexural properties, ductility, cracking behavior, and energy dissipation. The number of CC layers and the bonding method, which involved either the conventional externally bonded reinforcement (EBR) technique or the externally bonded reinforcement on grooves (EBROG) technique were studied. The experimental results revealed the superiority of the EBR method over the EBROG technique due to the uniform bond between CC and the concrete surface. Using the EBR technique, improvements of 35% and 51% were observed in the load‐carrying capacity of the beams strengthened with one and two CC layers, respectively. It is while for the beam with an improved loading capacity of 51%, the crack width decreased from 5.3 to 2.1 mm, and the energy dissipation increased by three times compared to the control specimen. Theoretical analysis also was performed to calculate the load‐carrying capacity of the RC beams strengthened with CC layers.