Flexural Strength, Elastic Modulus, and pH Profile of Self‐etch Resin Luting Cements

Abstract

To determine the flexural strength, modulus of elasticity, and 24-hour pH profile of three self-etching resin luting cements and to obtain comparative data for representative conventional resin and resin-modified glass ionomer luting cements. Three self-etching resin luting cements [RelyX Unicem (3M ESPE), Maxcem (Kerr), Embrace Wetbond (Pulpdent)] were tested and compared with two conventional resin cements [RelyX ARC (3M ESPE), Linkmax (GC)] plus two resin-modified glass ionomer luting cements [Fuji Plus (GC), RelyX Luting Plus (3M ESPE)]. Flexural strength and modulus of elasticity were determined using bar-shaped specimens (2 x 2 x 25 mm(3)) at 24 hours, using an Instron universal testing machine. Setting pH was measured using a flat-surface pH electrode at 0, 2, 5, 15, and 30 minutes and 1, 2, 4, 6, and 24 hours after mixing. Testing was performed under both dual-cured and self-cured conditions for all dual-cure cements. Data analysis included ANOVA and Tukey's test (p < 0.05). The self-etching cements showed similar flexural strength to the conventional resin cements, except for Embrace Wetbond self-cured, which was considerably lower. Modulus of elasticity results were both higher and lower than for conventional resin cements. All photopolymerized conventional and self-etch dual-cure cements showed markedly higher flexural strength and modulus than when solely self-cured. The resin-modified glass ionomer cements were characterized by lower flexural strength and elastic modulus. Self-etching resin cements showed lower initial pH (2.0 to 2.4) than conventional resin cements (4.8 to 5.2) and a wide range of final pH values (3.9 to 7.3) at 24 hours. One self-etching cement (Unicem) revealed a unique pH profile characterized by a more rapid rise in pH to neutrality both when dual-cured (15 minutes) and when auto-cured (1 hour). The self-etching resin cements evaluated in this study displayed disparate properties and cannot be considered a homogeneous group. Flexural strength properties were most uniform and were similar to those of the conventional resin cements, whereas moduli of elasticity showed greater variation. Setting pH profiles differed, depending on the brand and mode of cure, even within the same category of luting cement. All cements with dual-cure capability, both conventional and self-etch, showed significantly superior properties when photopolymerized.