Abstract
Fischer-Tropsch (FT) synthesis was carried out using 3D-printed stainless steel (SS) microreactors, containing channels of dimensions 500 μm × 500 μm ×2.7 cm, to study the effect of Fe, Ru, and Ni on Co-MCM-41 catalyst. The mono and bimetallic cobalt-based catalysts: 15 % Co-MCM-41, 10 %Co5% Ru MCM-41, 10 %Co 5%Ni MCM-41, and 10 %Co 5%Fe MCM-41 were synthesized using one-pot hydrothermal method and characterized by SEM-EDX, TEM, TPR, FTIR, XPS, and low and wide angle XRD techniques. All the catalysts exhibited high surface area without the loss of ordered mesoporous structure as confirmed by large BET surface areas (400- 1000 m2/g) and low angle XRD data. The metal nanoparticles were in the range of 35−50 nm and well dispersed in a hexagonal matrix of MCM-41. TPR data indicate that all other metal oxides except that of cobalt can be reduced with H2 below 600 °C. Cobalt is present most likely as cobalt silicates that can only be reduced with H2 at a temperature over 650 °C. The microchannels of SS reactor were uniformly coated by dip coating a slurry of the catalyst with polyvinyl alcohol (PVA). The catalytic performance for FT synthesis was carried out in the SS microreactor at atmospheric pressure in the temperature range of 180–300 °C with H2/CO molar ratio of 3. Incorporation of the second metal in the Co-MCM-41 framework and the operating temperature had a significant effect on CO conversion and selectivity towards C1-C4 alkanes in FT synthesis. While the highest CO conversion of 74 % was obtained for CoFe-MCM-41 at 240 °C, the highest selectivity towards butane (11 %) and propane (39 %) was observed for CoRu-MCM-41 at 240 °C and CoFe-MCM-41 at 210 °C, respectively. The rate of deactivation of the catalysts -followed the order: CoRu-MCM-41> CoNi-MCM-41> Co-MCM-41> CoFe-MCM-41, indicating that CoFe-MCM-41 is the most suitable catalyst for F–T synthesis in terms of long term stability.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.