First Report of White Mold Caused by Sclerotinia sclerotiorum on Echeveria gigantea in Mexico.

Abstract

Echeveria gigantea, native of Mexico (Reyes et al. 2011), holds economic importance as it is marketed as a potted plant and cut flower due to its drought-tolerant capabilities and aesthetic appeal. In September 2023, a field sampling was conducted at the Research Center in Horticulture and Native Plants (18°55'56.6" N, 98°24'01.5" W) of UPAEP University. Echeveria gigantea cv. Quilpalli plants with white mold symptoms were found in an area of 0.5 ha, with an incidence of 40% and severity of 50% on severely affected stems. The symptoms included chlorosis of older foliage, necrosis at the base of the stem, and soft rot with abundant white to gray mycelium and abundant production of irregular sclerotia resulting in wilted plants. The fungus was isolated from 30 symptomatic plants. Sclerotia were collected, sterilized in 3% NaOCl, rinsed with sterile distilled water (SDW), and plated on Potato Dextrose Agar (PDA) with sterile forceps. Subsequently, a dissecting needle was used to place fragments of mycelium directly on PDA. Plates were incubated at 23 °C in darkness. A total of 30 isolates were obtained using the hyphal-tip method, one from each diseased plant (15 isolates from sclerotia and 15 from mycelium). After 6 days, colonies had fast-growing, dense, cottony-white aerial mycelium forming irregular sclerotia of 3.67 ± 1.13 mm (n=100). Each Petri dish produced 32.47 ± 7.5 sclerotia (n=30), after 12 days. The sclerotia were initially white and gradually turned black. The isolates were tentatively identified as Sclerotinia sclerotiorum based on morphological characteristics (Saharan and Mehta 2008). Two isolates were selected for molecular identification. Genomic DNA was extracted using the CTAB protocol. The ITS region and the glyceraldehyde 3-phosphate dehydrogenase (G3PDH) gene were sequenced for two randomly selected isolates (White et al. 1990; Staats et al. 2005). The ITS and G3PDH sequences of the SsEg9 isolate were deposited in GenBank (ITS-OR816006; G3PDH-OR879212). BLAST analysis of the partial ITS (510 bp) and G3PDH (915 bp) sequences showed 100% and 99.78% similarity to S. sclerotiorum isolates (GenBank: MT101751 and MW082601). Pathogenicity was confirmed by inoculating 30 120-day-old E. gigantea cv. Quilpalli plants grown in pots with sterile soil. Ten sclerotia were deposited at the base of the stem, 10 mm below the soil surface. As control treatment, SDW was applied to 10 plants. The plants were placed in a greenhouse at 23 °C and 90% relative humidity. After 16 days, all inoculated plants displayed symptoms similar to those observed in the field. Control plants did not display any symptoms. The fungus was reisolated from the inoculated stems, fulfilling Koch's postulates. The pathogenicity tests were repeated three times. Recently S. sclerotiorum has been reported causing white mold on cabbage in the state of Puebla, Mexico (Terrones-Salgado et al. 2023). To the best of our knowledge, this is the first report of S. sclerotiorum causing white mold on E. gigantea in Mexico. Information about diseases affecting this plant is very limited, so this research is crucial for designing integrated management strategies and preventing spread to other production areas.