First Break Traveltime Picking Using Unsupervised Machine Learning and Super‐Virtual Refraction Interferometry

Abstract

AbstractAn accurate and trustworthy first break picking plays a key role in static correction calculations, velocity analysis, and deconvolution. First break traveltimes picking accuracy ensures correct and reliable seismic data processing results. Many methods are available to perform the first break pickings automatically. Most of these methods, however, are not robust when there is a low signal‐to‐noise ratio (SNR). In this study, to automatically determine the traveltimes of the first arrivals, we used the density‐based spatial clustering application with noise (DBSCAN) and the super‐virtual refraction interferometry (SVI). In the case of noisy data, using only DBSCAN for first break picking shows poor accuracy. To deal with this issue, SVI is employed to improve the SNR of the data, and then DBSCAN is applied again to the enhanced data for accurate picking. In the first step, DBSCAN is used to define a muting window for SVI. In the second step, SVI is employed to improve the first arrival SNR. In the third step, DBSCAN is applied to determine the final first arrival traveltime. The proposed approach is tested on synthetic and field data sets, where the manual and the cross‐correlation pickings are compared to the DBSCAN automatic pickings. We further test the proposed approach on a publicly available data set to benchmark our technique for first‐break accuracy with other established methods. Results show that the first arrival traveltime picks using the proposed approach are very accurate compared to manual picking.