Finite-element analysis of a combined fine-blanking and extrusion process

Abstract

This paper presents the characteristics of the combined fine-blanking and extrusion process and gives a detailed analysis of the process with the finite-element method. To carry out the simulation step by step and avoid the tendency to diverge in the calculations, the remeshing, tracing and golden section methods were developed and introduced into the finite-element program. Different boundary conditions were used in the simulation; the mesh distortion, field of material flow, and the stress and strain distributions were obtained. From the simulated results, the deformation characteristics under different boundary conditions were revealed. An experiment was also carried out to verify the simulated results. A large strain analysis technique was chosen to determine the effective strain distribution based on the experiment. The effective strain distributions from the simulation are in accordance with the effective strain distributions and the hardness distributions from the experiment. Copyright © 2005 John Wiley & Sons, Ltd.