Finite element modeling and simulation of piezoelectric wafer active sensors interaction with the host structure for structural health monitoring

Abstract

Crack detection with piezoelectric wafer active sensors (PWAS) is emerging as an effective and powerful technique in structural health monitoring (SHM). Modeling and simulation of PWAS and host structure play an important role in the SHM applications with PWAS. For decades finite element method has been extensively applied in the analysis of piezoelectric materials and structures. The advantage of finite element analysis over analytical solutions is that stress and electrical field measurements of complex geometries, and their variations throughout the device, are more readily calculated. FEM allows calculation of the stress and electric field distributions under static loads and under any applied electrical frequency, and so the effect of device geometry can be assessed and optimized without the need to manufacture and test numerous devices. Coupled field analysis taking both mechanical motions and electrical characteristics into account should all be employed to provide a systemic overview of the piezoelectric sensors/actuators (even arrays of them) and the host structures. This use of PWAS for SHM has followed two main paths: (a). Wave propagation (b). Electromechanical impedance; Previous research has shown that PWAS can detect damage using wave reflections, changes in wave signature, or changes in the electromechanical (E/M) impedance spectrum. The primary goal of this paper is to investigate the use of finite element method (FEM) to simulate various SHM methods with PWAS. For the simulation of Electro-mechanical (E/M) impedance technique, simple models, like free PWAS of different shapes and 1-dimmension beam with PWAS are investigated and the simulated structural E/M impedance was presented. For the wave propagation SHM technique, a long beam with several PWAS installed was studied. One PWAS is excited by tone burst signals and mechanical wave will propagate along the beam. The existence of a crack will affect the structure integrity and the echo reflected by crack can be observed through the simulations.