Abstract
In the present paper, a three-dimensional finite element model was used for simulating the grinding force at different cutting conditions. The effects of the wheel speed, feed and grinding depth on the grinding force per unit width were analyzed in detail. The results show that both the normal force and tangential force increase linearly with the increasing of feed and grinding depth, however, with the increasing of wheel speed, the grinding force decreases gradually. The predicted normal and tangential grinding forces were compared with those experimentally obtained and the results show reasonable agreement quantitatively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.