Abstract
Gears play an important role in every aspect of power and motion of transmission from historical period to modern day period . Due to this , gear design has become a complicated art.A considerable amount of research has been carried out to determine the amount of dynamic gear tooth loads acting.The findings of the dynamic load between the gear teeth results in difficulty for the designer.In this paper, an effort has been made to formulate a simple design procedure for calculating the dynamic load .Earlier the stiffness characteristics and deformation of the gear tooth were studied to predict the dynamic load acting. This was developed with the tooth assumed as a short cantilever.Whereas in reality, an involute profile exists in a spur gear tooth.Based on this reality, work has been done to model the exact profile of the tooth.Later ,the stiffness characteristics were carefully analysed and an improvement was thus made. It was proved that FEA is one such technique that can be used for predicting dynamic loads acting on a gear tooth.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
