Finite element analysis of stress distribution in autotransplanted molars

Abstract

ObjectiveThe biomechanical response of an autotransplanted tooth and surrounding bone to occlusal loads is not well-known. The aim of the present study was to investigate the effect of root form and occlusal morphology on stress distribution in autotransplanted teeth and surrounding bone by using finite element analysis (FEA). MethodsSeven FEA models representing different autotransplanted tooth situations were generated: (a) first molar, (b) third molar, (c) root canal-treated third molar, (d) root canal-treated, ankylosed, third molar, (e) crowned third molar, (f) crowned and root canal-treated third molar, (g) root canal-treated, ankylosed, and crowned third molar. Load (200 N) was applied on the occlusal surface, parallel to the long axis of the tooth. Maximum von Mises stress values on dentin and surrounding bone were calculated for each situation. ResultsDifferences in stress distribution were observed among models. In ankylosed model, stress was primarily observed at the coronal region of the tooth. The stress was observed more at the coronal region of the tooth in crowned models compared with the non-crowned models. The stress distribution was homogeneous with root canal-treated and crowned autotransplanted tooth. ConclusionsThe occlusal morphology and root form of the autotransplanted tooth affected the stress in surrounding bone at the transfer site and the biomechanical response of the tooth. The stress was more homogeneous in crowned tooth and primarily observed at the coronal region, which may decrease the risk for root resorption. Clinical significanceRoot configuration, occlusal form and root canal treatment induce significant changes on the stress distribution on teeth and bone, including characteristic stress concentration and increased stress values. Clinicians can consider crowning autotransplanted teeth for improved stress distribution within the tooth structure.