Finite element analysis of RC moment-resisting frames to assess effective slab width; a parametric study

Abstract

In reinforced concrete (RC) moment-resisting frames (MRFs) with cast-in-situ slabs, the slab action as tension flange during lateral loading enhances the flexural capacity of beams in negative moments. This enhancement may lead to strong beam-weak column unfavorable failure mode in these structures. Field observations of RC MRFs during strong ground motion indicated that the effective slab width values considered by the seismic provisions of the design codes are not adequate to guarantee the achievement of the design method of weak beam-strong column. An accurate estimation of effective slab width needs to assess factors such as geometrical characteristics of connection, continuity of models, and imposed story drift level. A 3D spatial two-story RC MRF was developed using finite element analysis (FEA) to explore the effect of mentioned factors on effective slab width. For finite element (FE) modeling of RC MRF, the concrete damaged plasticity (CDP) model is applied. The CDP model parameters are defined using a mesh-independent methodology introduced in the literature. Comparing the FEA results and results obtained from three half-scale RC MRFs, tested under reversed cyclic loading conditions showed an excellent correlation. The results predicted by the FE model in terms of lateral load–displacement response, reinforcement yielding sequence, crack patterns, and failure modes had a considerable agreement with test observations. The validated FE model was used to develop the other models to conduct a parametric study in the next step. Geometric parameters studied in this paper through numerical modeling were longitudinal and transverse beam length and height, and cross-sectional column dimension. Results of the parametric study showed that the effect of the ratio of transverse beam length to height is significantly more than the ratio of longitudinal beam length to height. The trend of effective slab width versus story drift depends on connection geometry, especially the ratio of transverse beam length to transverse beam height. Finally, an equation was driven to predict the effective slab width using linear regression analysis.