Abstract
Hot compression experiments of a nitrogen alloyed ultralow carbon stainless steel were performed in the temperature range of 1223–1423 K, at strain rates of 0.001–1 s−1, and with deformation amounts of 30–70% on a Gleeble-3500 thermal-simulator. Based on the results from thermo-physical simulation experiments and metallographic analyses, a physically-based constitutive model and a dynamic recrystallisation (DRX) model of the studied steel were derived, and the developed models were further embedded into a finite element method (FEM) software. The microstructure evolution of the studied steel under various hot deformation conditions was simulated by FEM, and the effects of deformation amount, strain rate and temperature on the microstructure evolution were clarified. The results obtained from the finite element analysis were verified by the experiments. The finding confirms that the thermal-mechanical FEM coupled with the developed constitutive model and DRX model can be used to accurately predict the microstructure evolution of the studied steel during hot deformation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
