Abstract
Since abrasive gels with single direction motion are very difficulty to achieve the smooth surfaces in the complex holes finishing during abrasive flow machining (AFM), therefore, the helical cores were proposed here to create the multiple motions of abrasive gels to get the even surface of the complex holes in AFM. The results showed that helical core with 5 spiral grooves and narrow gap between the core tip and the hole could obtain the even surface and fine surface roughness after AMF.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
