Abstract

A near-equiatomic NiTi shape memory alloy was fabricated by rapid solidification process through vacuum arc melting followed by vacuum suction casting in water-cooled thick copper mold. The rapidly solidified (or suction cast) NiTi alloy shows much finer grains and homogenous microstructure, in particular a uniform distribution of various fine precipitates, compared to the conventional cast one. The resultant alloy also exhibits the homogenous Ni distribution in the matrix of the alloy, allowing the martensitic transformation to take place throughout the NiTi alloy matrix simultaneously and resulting in sharper transformation peaks compared to the conventional cast alloy. Moreover, the suction cast NiTi alloy shows a significant improvement over the conventional cast one, in terms of possessing higher deformation recovery rates and displaying the increased compressive strength and damping capacity by 4% and 20%, respectively.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.