Final report of CCQM-K129 Measurement of Mole Fractions of Cu, In, Ga and Se in Cu(In,Ga)Se2 Films

K J Kim ,Jong Shik Jang ,Bráulio S Archanjo ,C Streeck ,Joe Bennett ,B Beckhoff ,D Simon ,Thomas Wirth ,C A Achete ,Carlos Eduardo Cardoso Galhardo ,J Suh ,H Wang ,Wolfgang Unger ,Steve J Spencer ,J C Damasceno ,Joyce R Araújo ,Tatsuya Fujimoto ,V D Hodoroaba ,M Wang ,S Terauchi ,Atsushi Kurokawa ,A S Kim ,Alexander G Shard

doi:10.1088/0026-1394/53/1a/08011

Abstract

CCQM key comparison K-129 for the quantitative analysis of Cu(In,Ga)Se2 (CIGS) films has been performed by the Surface Analysis Working Group (SAWG) of the Consultative Committee for Amount of Substance (CCQM). The objective of this key comparison is to compare the equivalency of the National Metrology Institutes (NMIs) and Designated Institutes (DIs) for the measurement of mole fractions of Cu, In, Ga and Se in a thin CIGS film. The measurand of this key comparison is the average mole fractions of Cu, In, Ga and Se of a test CIGS alloy film in the unit of mole fraction (mol/mol). Mole fraction with the metrological unit of % mol/mol can be practically converted to atomic fraction with the unit of at %.In this key comparison, a CIGS film with certified mole fractions was supplied as a reference specimen to determine the relative sensitivity factors (RSFs) of Cu, In, Ga and Se. The mole fractions of the reference specimen were certified by isotope dilution - inductively coupled plasma/mass spectrometry (ID-ICP/MS). A total number counting (TNC) method was recommended as a method to determine the signal intensities of the constituent elements acquired in the depth profiles by Secondary Ion Mass Spectrometry (SIMS), X-ray Photoelectron Spectroscopy (XPS) and Auger Electron Spectroscopy (AES). Seven NMIs and one DI participated in this key comparison. The mole fractions of the CIGS films were measured by depth profiling based-SIMS, AES and XPS.In this key comparison, the average degrees of equivalence uncertainties for Cu, In, Ga and Se are 0.0093 mol/mol, 0.0123 mol/mol, 0.0047 mol/mol and 0.0228 mol/mol, respectively.Main textTo reach the main text of this paper, click on Final Report. Note that this text is that which appears in Appendix B of the BIPM key comparison database kcdb.bipm.org/.The final report has been peer-reviewed and approved for publication by the CCQM, according to the provisions of the CIPM Mutual Recognition Arrangement (CIPM MRA).

Full Text