Fibrin Binding of Plasminogen Coated Liposomes In Vitro

Abstract

In this study, the fibrin binding properties of liposomes containing a number of plasminogen (Plg) molecules on the outside were compared to those of free (non-liposomal) Plg in an in vitro model system. Fibrin monolayer coated 96-wells plates were used, containing fibrin monomer at a density of around 3.4 to 3.9 x 10(-4) nmol/cm2. These densities are similar to liposomal Plg-densities, thus allowing multivalent interactions to occur. In the panel of experimental conditions that was chosen, binding of free Plg and liposomes with Plg showed three main differences in characteristics. Firstly, in the fibrin binding of Plg-liposomes not all Plg may be involved, but on the average 40% of the total amount of liposomal Plg. This was shown by lysing the liposomes after binding to the fibrin and estimation of truly bound Plg. With Plg-densities on the liposomes below the fibrin binding sites density, the maximal number of bound Plg molecules remains below the amount of available fibrin binding sites. Secondly, a higher binding rate by at least one order of magnitude was observed for liposomes with Plg compared to free Plg. Thirdly, liposomes with Plg exhibit a fibrin binding affinity which increases with Plg-density, because of the multivalent character of interaction. Liposomal Plg can successfully compete for fibrin binding sites with a 100 fold higher concentration of free Plg. These in vitro findings indicate that in view of avid and rapid fibrin binding, liposomes with attached plasminogen may be suitable for in vivo targeting to fibrin based thrombi.