Abstract
Injection molded polymer composite gears are being used in many power and or motion transmission applications. In order to widen the utilization of reinforced polymers for precision motion transmission and noise less applications, the accuracy of molded gears should be increased. Since the injection molded gear accuracy is significantly influenced by the material shrinkage behaviour, there is a need to understand the influence of fiber orientation and gate location on part shrinkage behaviour and hence the gear accuracy. Unreinforced and 20% short glass fiber reinforced Nylon 6/6 spur gears were injection molded in the laboratory and computer aided simulations of gear manufacturing was also carried out. Results of the mold flow simulation of gear manufacturing were correlated with the actual fiber orientation and measured major geometrical parameters of the molded gears. Actual orientation of the fibers near the tooth profile, weld line region and injection points of molded gears were observed using optical microscope and correlated with predicted fiber orientation.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
