Fiber optic acoustic emission sensing system using a SOA-based fiber ring laser

Abstract

Large bridges and industrial equipment may encounter natural disasters (earthquakes, tsunamis, etc.) and man-made effects during their service period. When they are subjected to these external influences, the structure may be deformed or even cracked, and the internal stress of the structure can also cause the occurrence of acoustic emission events. In this work, we report a fiber-optic acoustic emission sensing system using a semiconductor optical amplifier (SOA)-based fiber-ring laser source including a non-tunable fiber Fabry-Perot filter (NTFFPF) to demodulate dynamic signals from fiber Bragg grating (FBG) sensors. The shift in the FBG reflection spectrum caused by external strain is demodulated by the NTFFPF in the ring laser cavity, which ultimately produces an amplified output signal. The proposed system was used to detect the high-frequency acoustic emission signals generated by the piezoelectric buzzer. Experimental results show that this system can demodulate high-frequency acoustic emission signals with a good response and a high signal-to-noise ratio up to 21.6 dB. At the same time, acoustic emission signals generated by an ultrasonic vibrator with a frequency of 40 kHz are detected simultaneously with a FBG sensor and a piezoelectric sensor placed in the middle of a square aluminum plate. The angle-dependent acoustic emission measurement is performed by placing the ultrasonic vibrator at different angles from 0° to 90° in the radial direction of the FBG sensor. The results show that the sensor system can accurately detect the high-frequency acoustic emission signals on the aluminum plate and larger signal amplitude can be obtained when the angle between the ultrasonic vibrator and the FBG sensor axial is in the range of 0-60°. The fiber ring laser sensing system proposed in this paper has application prospects in many aspects, such as acoustic emission source location and ultrasonic detection.