Abstract
Whereas core-mode reflection and core-mode-to-radiation-mode coupling in tilted fiber Bragg gratings is well understood, as is coupling between a core mode and higher-order core and cladding modes in untilted gratings, here we analyze in detail the coupling among core modes and cladding modes in reflective and transmissive tilted fiber gratings. We show that strong coupling between an LP(01) core mode and the exact (1m) cladding modes occurs in a transmissive tilted grating for nearly any tilt angle except angles close to 90 degrees, whereas the LP(01)-to-(lm) cladding mode coupling (l not equal 1) is appreciable only for tilt angles just below 90 degrees (approximately 88 degrees). In a reflective grating, strong coupling between the LP(01) core mode and the exact (1m) cladding modes occurs only for angles less than approximately 5 degrees, whereas coupling to (1m) cladding modes for m > 1 occurs only for angles greater than approximately 5 degrees. Coupling among bound core modes exhibits a similar behavior, except that in general the coupling is stronger. Experimentally we show coupling to both higher-order bound core modes and cladding modes in a transmissive tilted grating at visible and near-infrared wavelengths.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
