Abstract
AbstractThe following contribution focuses on the FEM‐simulation of “Die‐Less‐Hydroforming” using LS‐DYNA. That specific forming technology is used to create structures by inflating initial seal‐welded flat 2D blanks as well as 3D hollow bodies without using any die, mould or punch in contrast to conventional hydroforming (e.g. tube hydroforming or hydromechanical deep drawing). (© 2014 Wiley‐VCH Verlag GmbH & Co. KGaA, Weinheim)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.