FEM calculation of residual stresses induced by laser shock processing in stainless steels

Abstract

Laser shock processing, also known as laser shock peening, generates through a laser-induced plasma, plastic deformation and compressive residual stresses in materials for improved fatigue or stress corrosion cracking resistances. The calculation of mechanical effects is rather complex, due to the severity of the pressure loading imparted in a very short time period (in the ns regime). This produces very high strain rates (106 s−1), which necessitate a precise determination of dynamic properties.Finite element techniques have been applied to predict the residual stress fields induced in two different stainless steels, combining shock wave hydrodynamics and strain rate dependent mechanical behaviour. The predicted residual stress fields for single or multiple laser processes were correlated with those from experimental data, with a specific focus on the influence of process parameters such as pressure pulse amplitude and duration, laser spot size or sacrificial overlay.Among other results, simulations confirmed that the affected depths increased with pulse duration, peak pressure and cyclic deformations, thus reaching much deeper layers (> 0.5 mm) than with any other conventional surface processing. To improve simulations, the use of experimental VISAR determinations to determine pressure loadings and elastic limits under shock conditions (revealing different strain-rate dependences for the two stainless steels considered) was shown to be a key point.Finally, the influence of protective coatings and, more precisely, the simulation of a thermo-mechanical uncoated laser shock processing were addressed and successfully compared with experiments, exhibiting a large tensile surface stress peak affecting a few tenths of micrometres and a compressive sub-surface stress field.