Feldspar dissolution rates measured using phase-shift interferometry: Implications to CO2 underground sequestration

Abstract

To assess CO 2 underground sequestration from a geochemical viewpoint, the anorthite dissolution rate, which is an important parameter of risk analysis, was measured in a CO 2 –water system. The authors sought to obtain precise dissolution rate data in a short time observing a crystal surface on a nanoscale. For this purpose, phase-shift interferometry was applied. Using this method, uncertainty of the reactive surface area that is imparted on calculation of the dissolution rate constant can also be avoided. The time-course profile of vertical retreat of the surface revealed that the anorthite dissolution process changes from the initial transient state to a later steady state, which is consistent with results of numerous precedent studies. The transient dissolution rate depends strongly on local features (e.g., density of defects, variation of chemical compositions) of the crystal surface, rather than on temperature. Therefore, it is very important to determine the original properties of the anorthite surface for the examination of subsequent dissolution process. Contrary to general expectations, the anorthite dissolution can alter the physical properties of reservoir rock immediately after CO 2 injection. The simple estimation using the anorthite dissolution rate obtained in this study, which was done as a test case for the CO 2 underground sequestration project conducted by RITE, revealed that porosity of reservoir rock increased about 2% (23–23.4%) of initial values during 60 a. That change in physical property in such a short time might enhance the diffusion of injected CO 2 and formation water, and therefore accelerate further geochemical reactions. Results of this study demonstrate that the geochemical water–rock interaction, which is generally regarded as a longer-term phenomenon than various physical processes, can also affect the reservoir system from the initial stage.