Abstract
Trend in die/mold machining is to produce highly quailed surface using the high-speed hard machining with the ball-end cutter. The ball-end milling is, however, less efficiency than the flat end milling. It is important to optimize the feedrate that gives the maximum material removal rate constrained by an allowable surface roughness. The state-of-art of the CBN ball-end cutter technology allows increasing the tooth feed for high-speed and high-efficiency machining. However, because the spherical shape of the cutter can result in the scallop-liked cusps on the machined surface, the surface roughness consideration makes a feedrate limitation to the CBN cutter. In this paper, the optimization of the feedrate by considering the generated-scallop effect of the ball-end cutter has been studied. It was found that the tooth feed must be kept within one third of the path pick in order to keep the feed-interval scallop height not over the path-interval scallop height. Therefore, the potential capability of the CBN cutter for the larger tooth feed (i.e. high efficient) machining can not be fully exploited. It was found a notch-cut on the center of the ball-end cutter reduced the feed-interval cusp height, thus allowing an increased feedrate of more than 50% compared with the standard ball-end cutter. If the parameters of the notch-cut profile can be optimized, it is believed that the feedrate can be further increased.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Machine Tools and Manufacture
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.