Feasibility study using longitudinal bioelectrical impedance analysis to evaluate body water status during fluid resuscitation in a swine sepsis model

Abstract

Fluid resuscitation is crucial in the initial management of sepsis; however, little is known about the serial changes and overall distribution of fluids administered into the body. To identify the feasibility of longitudinal bioelectrical impedance analysis during fluid treatment, a preclinical porcine model of Escherichia coli-induced sepsis was used. After sepsis induction, pigs were treated with fluid and vasopressors and monitored for up to 12 h after bacterial infusion or until death. Bipolar electrodes for bioelectrical impedance analysis were attached to the left extremities and measurements were performed every 10 min. Among the 12 subjects, 7 pigs expired during the experiment, and the median survival was 9.5 h. As sepsis progressed with an increase in cumulative fluid balance, R0 [∝ 1/extracellular water (ECW)] decreased, while Ri [∝ 1/intracellular water (ICW)] and ratio of extracellular water to total body water (ECW/TBW) increased. The phase angle constantly decreased throughout the monitoring period, and all non-survivors died when the phase angle decreased by more than 10%. Among the variables, ΔR0 and Δphase angle showed moderate negative correlations, and ΔECW/TBW showed a moderate positive correlation with the hourly fluid balance. Compared to survivors, a greater increase in ΔECW/TBW and a decrease in phase angle were observed in non-survivors over time, with an increase in cumulative fluid balance. Differences in ΔECW/TBW and phase angle emerged at 240 min when the difference in cumulative fluid balance between the two groups (survivors vs non-survivors) exceeded 1000 mL. In conclusion, continuous measurements of bioelectrical impedance analysis in a porcine sepsis model are feasible and may reflect changes in the body water profile during fluid resuscitation.