Abstract
ABSTRACTThe distribution of fibers in the composite (which takes into account both their locations and orientations) is one of the important factors that affect the mechanical properties of FRCs. However, this parameter depends on various factors during composite fabrication, and controlling the distribution of fibers in the produced material represents a significant challenge. In this study, the applicability of three-dimensional (3D) printing technique for controlling fiber distributions was evaluated. The fibers fabricated using a 3D printer were placed inside a mold to produce cementitious composites. Three-point bending tests were conducted and the results of the experiment were discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
