Abstract
The use of the multi-spindle head in drilling technology can reduce the drilling cycle time by simultaneously producing multiple holes in one go. However, selecting the appropriate drill material and geometry is critical to overcoming the challenges of multi-hole drilling to ensure high-quality holes. This study investigates the use of the multi-spindle head with different tool configuration, tool materials and tool geometry during multi-hole simultaneous drilling of Al2024. A comparison is made among the high-speed steel drills (diameter: 6 mm; point angle: 118°) and two different carbide drills (diameter: 6 mm and 10 mm; point angle: 140°) as well as the maximum and minimum possible centre to centre tool distances of the multi-spindle head. The experiments are based on measuring the thrust force, evaluating the hole quality in terms of surface roughness and burrs, the formation of chips and post-drilling tool conditions. The results showed that carbide drills with high point angle and smaller diameter generated less thrust force, produced higher quality holes, and formed less built-up edge due to short chips. Besides, tools of the multi-spindle head can be adjusted in any position without affecting the hole quality which is useful for increasing productivity at a higher rate in manufacturing industries.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The International Journal of Advanced Manufacturing Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
