Abstract
The preparation of matrix-matched material for elemental quantitative analysis in rice flour matrix is proposed here for the first time as part of a feasibility study using the SN-ICP-MS and LA-ICP-MS methods. It was prepared via the spiking process in colloidal solution of rice flour with different levels of arsenic (As), cadmium (Cd) and lead (Pb), followed by drying in a climatic chamber. Comparative studies of the results on external calibration and gravimetric standard addition ICP-MS approaches through the use of calibration standard solutions were discussed. Method bias from the external calibration method was investigated, demonstrating the systematic effect arising from the sample matrix. Characterizing the concentration of measurands was then reasonably proposed using the gravimetric standard addition ICP-MS. Using powdered rice matrix reference material for ICP-MS calibration following acid digestion, the study showed a good agreement of recovery studies. A feasibility study of the LA-ICP-MS method as a direct solid analysis performed on the matrix-matched standard was then discussed. In the study, large fluctuation of signals was found for constructing calibration curve, generating poor linearity, especially for As and Pb, although yttrium (Y) as internal standard was applied. This might be ascribed to a limited microscale of homogeneity, and particularly laser-induced preferential evaporation of volatile elements. Using a number of measured data points, the mean and median were statistically recommended to improve precision. An attempt to use of similar matrix in both standard and sample is a critical point to consider to minimize the elemental fractionation effect. The proposed approach to prepare matrix-matched material could be a potential means for achieving elemental quantitation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have