Feasibility and potential of three-dimensional printing in laryngotracheal stenosis.

Abstract

The use of three-dimensional printing has been rapidly expanding over the last several decades. Virtual surgical three-dimensional simulation and planning has been shown to increase efficiency and accuracy in various clinical scenarios. To report the feasibility of three-dimensional printing in paediatric laryngotracheal stenosis and discuss potential applications of three-dimensional printed models in airway surgery. Retrospective case series in a tertiary care aerodigestive centre. Three-dimensional printing was undertaken in two cases of paediatric laryngotracheal stenosis. One patient with grade 4 subglottic stenosis with posterior glottic involvement underwent an extended partial cricotracheal reconstruction. Another patient with grade 4 tracheal stenosis underwent tracheal resection and end-to-end anastomosis. Models of both tracheas were printed using PolyJet technology from a Stratasys Connex2 printer. It is feasible to demonstrate stenosis in three-dimensional printed models, allowing for patient-specific pre-operative surgical simulation. The models serve as an educational tool for patients' understanding of the surgery, and for teaching residents and fellows.