Abstract

High performance miniaturized electronic devices require enhanced, compact and reliable thermal management system. As an efficient compact space cooling technique, flow boiling in microchannels has recently gained wide acceptance. However, weak buoyancy effects and microgravity in avionics and numerous space systems operations hinder the performance of flow boiling microchannel thermal management system due to poor bubble departure capacity and unfavorable development of flow regimes. Here we report the flow boiling silicon nanowires (SiNWs) microchannels which can favorably regulate two-phase flow regimes by enhancing explosive boiling, minimizing bubble departure diameter, and smoothing flow regime transition. Extensive experimental investigations along with high speed visualizations are performed. The experiments are performed with the dielectric fluid HFE-7100 in a forced convection loop for wide range of heat and mass fluxes. High speed flow visualizations have been employed at up to 70 k frames per second (fps) to understand the boiling mechanism in terms of bubble dynamics, flow patterns, and flow regime developments for SiNWs microchannels. These studies show that SiNWs reduce intermittent flow regimes (slug/churn), improve rewetting and maintain thin liquid film at wall. Therefore, flow boiling in SiNW microchannels is promising to thermal management owing to its high heat transfer rate with low pressure drop and negligible microgravity sensitivity.

Highlights

  • Boiling fluid can dissipate significantly higher heat flux utilizing the latent heat of fluid with a smaller flow rate compare to single-phase counterpart

  • critical heat flux (CHF) was enhanced for up-flow cases due to the establishment of annular flow regime, whereas, CHF was even lower than the low flow rate experiments for down-flow case due to the stagnation of bubble

  • To understand the effect of surface properties on bubble dynamics, flow pattern transition and flow regime development in flow boiling microchannels, a series of high-speed visualization studies were employed from the top of both the plainwall and silicon nanowires (SiNWs) microchannels

Read more

Summary

Introduction

Boiling fluid can dissipate significantly higher heat flux utilizing the latent heat of fluid with a smaller flow rate compare to single-phase counterpart. Simoneau and ­Simon[10, 11] studied the forced convection boiling of nitrogen in vertical channel and observed lower critical heat flux (CHF) for down-flow as compared to upflow test at the same low liquid velocity. The aim of this work was to address NASA’s needs that is especially favorable for applications in microgravity by creating a new, unified and ultra-efficient flow boiling pattern in two-phase technologies This SiNW microchannel has the ability to minimize the transitional flow boiling regimes, i.e., slug/churn/wavy patterns to a single annular flow starting from onset of nucleate boiling (ONB) to CHF condition by guiding the flow structure in two aspects: reducing bubble size and changing the direction of the surface tension force from the cross-sectional plane to the inner-wall ­plane[29, 30]. Further studies are needed to investigate the flow boiling characteristics in SiNW microchannels using dielectric fluids

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call