Abstract
A new method to detect component faults in analog circuits is proposed in this paper. Network parameters like driving point impedance, transfer impedance, voltage gain and current gain are used to detect component faults in analog circuits as these network parameters are sensitive to the components of the circuit. Using montecarlo simulation each component of the circuit is varied within its tolerance limit and the minimum and the maximum values of each network parameter are found for fault free circuit. At the time of testing, the network parameters are found for the injected fault and if any one or more network parameters is exceeding its predetermined bound limits then the circuit is confirmed faulty. The proposed method is validated through second order Sallenkey band pass filter and fourth order Chebyshev low pass filter circuits. Numerical results are presented to clarify the proposed method and prove its efficiency.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
