Fatigue Properties of Thixoformed Al-6wt%Si-2.5wt%Cu

Abstract

One of the main functions of semisolid metal alloy forming processes, notably rheocasting and thixoforming, is the manufacture of parts, casings and frames for mechanical assemblies and systems. These parts not only must have the required minimum mechanical properties in terms of yield strength and elongation, but also must be able to withstand cyclic tensile and compressive forces. However, there is little fatigue strength data for the materials used for these parts. The present work seeks to fill this gap by determining the fatigue limit at 107 cycles of Al-6.0wt%Si-2.5wt%Cu alloy, or simply Al6Si2.5Cu, thixoformed in a pneumatic press at 585 °C (the temperature corresponding to 40 % solid fraction) with isothermal treatment times of 30 and 60 seconds. The parts were also subjected to T6 heat treatment, for which they were solution heat treated at a temperature of 520 °C for 4 hours followed by aging at 180 °C for 10 hours. For all the conditions tested, the microstructures were characterized to determine the grain size, appearance and shape of the silicon particles, in addition to the residual porosity. For the best conditions observed, 30 s holding time and T6 heat treatment, the grain size varied between 100 µm and 130 µm; the shape factor was around 0.60, indicating an excellent degree of roundness; and there was low residual porosity of around 0.3 %, resulting in a yield strength of up to 240 MPa with 4.5 % elongation. The average fatigue strength was estimated by the staircase method and was between 95 MPa and 98 MPa for 107 cycles.