Abstract
Advance high strength steels (AHSS), like dual phase (DP) and transformation induced plasticity (TRIP) steels, offer high strength and toughness combined with excellent uniform elongation. However, the higher alloying content of these steels limit their weldability and the thermal cycle of welding processes destroys the carefully designed microstructure. This will result in inferior mechanical properties of the joint. Therefore, joining processes with a low heat input, like brazing, are recommendable. Data regarding mechanical properties of joints in DP and TRIP steel is limited, especially for brazed joints. Results with respect to the fatigue lifetime of laser brazed butt joints are presented. In DP and TRIP steel, crack initiation takes place at the braze toe. In DP steel the crack propagates through the base metal. In TRIP steel, however, the crack may either follow the interface or may continue through the steel depending on the maximum stress level. The different failure mechanisms are explained on the basis of process conditions, the microstructure and the stress state.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
