Abstract
To investigate the mechanism of base-metal cracking on diaphragm cutout in a self-anchored suspension bridge with orthotropic steel deck (OSD), multi-scale finite element models were established to obtain stress response at cutout detail under the passage of wheel loads. Fatigue life was evaluated based on nominal stress method and hot-spot stress method. The results indicated that the length of the longitudinal influence line for detail stress to wheel loads approximately equalled to twice the diaphragm spacing. The wheel loading location of maximum stress was the front wheel of middle-axle group 0.3 m from the diaphragm, and the stress was dominated by in-plane stress. The nominal stress was hard to define at cutout detail for high stress concentration, and the hot-spot stress was preferred to fatigue assessment based on S-N curve of FAT125, also nominal stress should be extracted at the location 5.0 mm from cutout edge. Cutout shape of Highway Bridge in Eurocode was suggested, and diaphragm thickness should not be below 12 mm. The cutout cracking was caused by poor cutout shape, thin diaphragm, high truck traffic volume and overloaded wheel loads, while undesirable fabrication control and large residual stress might also contribute to the cracking.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.