Abstract
BackgroundCardiovascular MRI (CMR) faces challenges due to the interference of bright fat signals in visualizing structures like coronary arteries. Effective fat suppression is crucial, especially when using whole-heart CMR techniques. Conventional methods often fall short due to rapid fat signal recovery, leading to residual fat content hindering visualization. Water-selective off-resonant radiofrequency (RF) pulses have been proposed but come with tradeoffs between pulse duration, which increases scan time, and increased RF energy deposit, which limits their applicability due to specific absorption rate (SAR) constraints. The study introduces a lipid-insensitive binomial off-resonant (LIBOR) RF pulse, which addresses concerns about SAR and scan time, and aims to provide a comprehensive quantitative comparison with published off-resonant RF pulses for CMR at 3T. MethodsA short (1ms) LIBOR pulse, with reduced RF power requirements, was developed and implemented in a free-breathing respiratory-self-navigated 3D radial whole-heart CMR sequence at 3T. A binomial off-resonant rectangular (BORR) pulse with matched duration, as well as previously published lipid-insensitive binomial off-resonant excitation (LIBRE) pulses (1ms and 2.2ms), were implemented and optimized for fat suppression in numerical simulations and validated in volunteers (n=3). Whole-heart CMR was performed in volunteers(n=10) with all four pulses. The signal-to-noise ratio (SNR) of ventricular blood, skeletal muscle, myocardium, and subcutaneous fat and the coronary vessel detection rates and sharpness were compared. ResultsExperimental results validated numerical findings and near homogeneous fat suppression was achieved with all four pulses. Comparing the short RF pulses (1ms), LIBOR reduced the RF power nearly two-fold compared with LIBRE, and three-fold compared with BORR, and LIBOR significantly decreased overall fat SNR from cardiac scans, compared to LIBRE and BORR. The reduction in RF pulse duration (from 2.2ms to 1ms) shortened the whole-heart acquisition from 8.5min to 7min. No significant differences in coronary arteries detection and sharpness were found when comparing all four pulses. ConclusionLIBOR pulses enabled whole-heart CMR under 7minutes at 3T, with large volume fat signal suppression, while reducing RF power compared with LIBRE and BORR pulses. LIBOR is an excellent candidate to address SAR problems encountered in CMR sequences where fat suppression remains challenging and short RF pulses are required. AVAILABILITY OF DATA AND MATERIALSAn online repository containing the anonymized human MRI raw data, as well as RF pulse shapes used in this study is publicly available at:https://zenodo.org/records/8338079(PART 1: KNEE V1-V3, HEART V1-V5)https://zenodo.org/records/10715769 (PART 2: HEART V6-V10)Matlab code to 1) simulate the different RF pulses within a GRE sequence and 2) to read and display the anonymized raw data is available from: https://github.com/QIS-MRI/LIBOR_LIBRE_BORR_SimulationCodeThe compiled research sequence can be requested through the Teamplay platform of Siemens Healthineers.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
