Abstract
Fat bloom development and associated changes in microstructure, texture, appearance and melting properties were studied. Dark chocolates varying in particle size (PS) ( D 90 of 18, 25, 35 and 50 μm) were processed and pre-crystallised to under-temper regime. Bloom was induced by storing products under ambient conditions (18 ± 2 °C, RH 50%) and changes in texture, surface whiteness, gloss and melting properties evaluated on cooling and after every 24 h in storage until reaching asymptotic values. Microstructure of products were characterised during blooming using stereoscopic binocular microscopy. Measurements on texture and surface whiteness showed initial rapid increases with consequential reductions in gloss within the first 96 h, followed by gradually decreasing gradient until reaching asymptotic levels. Storage influenced melting properties ( T onset, T end, T peak and ΔH melt) in products causing polymorphic transformation from βIV to βVI within 72 h. Micrographs showed similar surface crystalline network structure and inter-particle interactions among products from different PS after tempering, and bloom initiation occurred within 24 h in storage resulting in appearance of both liquid and unstable fat on the surface of products. The unstable fat then re-crystallised during storage into more stable polymorphs and crystal growth was promoted by Ostwald ripening (larger crystals growing at the expense of smaller ones), with the appearance of white crystalline structure which spread gradually throughout the chocolate mass after 96 h. Product containing the largest PS (50 μm) showed the fastest fat bloom rate, with the smallest PS (18 μm) the least, attributed mainly to hydrodynamic forces by capillary action. It was hypothesised that fat bloom development was initiated by capillarity, followed by growth of re-crystallised fat by diffusion across the entire chocolate mass until fully bloomed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.