Abstract
The influence of vent ducts on gas explosions was investigated with the aim of determining whether the use of larger area of the vent duct than the vent, would reduce the overpressure in vented duct explosion. A 0.2 m 3 cylindrical vessel was used with L/D (length to diameter) of 2, at the limit of applicability of current explosion venting design guidance. Only end ignition was considered in this study with a vent coefficient, K of 16.4. Methane/air mixtures over a range of equivalence ratio, Ф (0.68, 0.84 and 1.05) have been used. Results showed that while there is no significant difference in maximum pressure for larger vent duct as compared to a free discharge vent at lean mixtures, however, a significant increase of overpressure ∼ 1.4 bar was obtained in reactive mixtures i.e. Ф = 1.05. This was due to the high unburnt gas velocities induced in the vent duct by the most reactive explosion, creating very high turbulence levels at the vent duct inlet which gave rise to very fast flames and very high back pressures. Flame speeds in the vent duct of up to 500 m/s were measured for the most reactive mixture in the larger vent duct. The results were not predicted by the current US and European vent design guidance.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
